Instructions (EN)
Reusable screw fastener for festival wristbands (4-pack with screw tools).
Assembly of the fastener
1
Remove seal
Carefully remove the single-use seal from the wristband.
2
Thread the band
Pass the band through the fastener, making sure it lies flat.
3
Screw in
Insert the screw using the supplied tool – do not overtighten.
4
Check fit
Check that the fastener holds securely. To remove, simply unscrew.
Tip: Hand-tight is enough. Overtightening may damage the part.
Safety & notes
▶ Age & safety notes
- Not suitable for children under 3 years – choking hazard due to small parts.
- Keep out of reach of children. Use only as intended.
▶ Temperature & care
- Keep away from heat. High temperatures can deform plastic (e.g., do not leave in a hot car).
- Not dishwasher safe; clean with a damp cloth.
▶ Liability
No liability for improper use or damage resulting from failure to observe these notes.
Material
PLA/PLA+ – produced using FDM 3D printing. Lightweight, strong, designed for the stated purpose.
3D View
Contact: amazon@goose-media.de
Language selection